Install plastic ceiling medallion

Category: hobbies and interests woodworking. Clean the area on the ceiling where the medallion will rest using soap, water and an abrasive sponge. Center the light fixture's cover plate on the face of the medallion. What are ceiling medallions used for? Do I need a ceiling fan in the kitchen? What are ceiling medallions made of? How do you glue a ceiling rose? How do you remove a decorative ceiling medallion? How do you size ceiling medallions?

How do you fix a hole in a ceiling light fixture? How do you cover a hole in a light fixture? Permanent Covering. How do you cut drywall ceiling? Drywall Saw. Place the tip of the blade where you want to begin your cut. Please enter your comment! Please enter your name here. You have entered an incorrect email address! Recommended For You. How to Install Canless Recessed Lights. It helps to mark the perimeter on the ceiling for easy replacement once the glue has been applied to the back.

The urethane material is rigid, so it will not sag when installed on the ceiling. The urethane medallion provides a solid backing for a flush mounting surface. The second urethane medallion replaced a flimsy plastic medallion that was sagging on one side. The arrow points to the noticeable gap on the edge. Liberally apply construction adhesive to the rear of the two-piece medallion.

A variety of styles are available, such as this ornate medallion with a very classical look. Fasten the medallion into the ceiling framing with countersunk trim-head screws. Cover the screw heads with color-matched wood filler. Finish up the installation with paint and caulking. I needed one hole in the center that was large enough to bring the wires through and then I needed a little slot on each side for the bolts to go up into the ceiling.

Once the holes were traced I put a drill bit on my screw gun and removed the traced areas. Since the canopy would cover the hole, I knew that I didn't have to be too precise when I made the cut. Normally at this point I would have put a polyurethane adhesive on the back side of the medallion to secure it up to the ceiling, but I wanted to do a dry run quickly just to make sure I had everything in place. I put the medallion up to the ceiling and tightened the bolts through the fixture.

Everything fit perfectly and with the bolts holding it up in place it was so snug to the ceiling that I decided to bypass putting any adhesive on the back. So for this project I installed it without adhesive and without any nails. With the medallion in place my next step was putting together the parts of the fan.